Enabling a High-Throughput Characterization of Microscale Interfaces within Coated Cathode Particles

Peer reviewed: 
Yes, item is peer reviewed.
Scholarly level: 
Faculty/Staff
Final version published as: 

Taylor, A. K.; Nesvaderani, F.; Ovens, J. S.; Campbell, S.; Gates, B. D.,* "Enabling a High-Throughput Characterization of Microscale Interfaces within Coated Cathode Particles," ACS Applied Energy Materials, in press, 2021. https://pubs.acs.org/doi/full/10.1021/acsaem.1c01816

Date created: 
2021-09-10
Identifier: 
DOI: 10.1021/acsaem.1c01816
Keywords: 
High voltage spinel
Lithium ion batteries
Lithium niobate
Cathode coating
Ultramicrotome
Cross-section
Abstract: 

Lithium ion batteries represent an emerging field. The development of battery materials could benefit from quick techniques that enable atomic-level diagnostics. High performance cathodes, such as high-voltage spinel, often require coatings to protect against the destructive electrochemical environments at the particle-to-electrolyte interface. The preparations of these coating are still in the early phases of development, and their analytical inspection by high resolution scanning and transmission electron microscopy (HR-S/TEM) techniques presents a significant challenge due to the microscale dimensions of cathode particles. In this work, a high throughput ultramicrotome technique was assessed for the characterization of the particle to coating interface. The ultramicrotome technique enabled the rapid preparation of cross-sections with a thickness of 126 ± 66 nm as determined by electron energy loss spectroscopy (EELS) measurements. Cathode particles composed of high-voltage spinel, LiNi0.5Mn1.5O4 (LNMO), coated with lithium niobate (LiNbO3) were synthesized and cross-sections were inspected using HR-S/TEM techniques. These ultra-thin cross-sections enabled the ability to obtain nanoscale information regarding the composition and crystallinity of the particle-to-coating interface over lateral areas of >1 µm. Accessible correlations between the electrochemical performance of the LiNbO3 coated LNMO particles and the HR-S/TEM results were enabled by the high-throughput method. Discharge capacity measurements were acquired over a series of 100 electrochemical cycles for both the LiNbO3 coated and the as-prepared LNMO particles. The limitations of the ultramicrotome technique are also discussed herein with respect to the coating morphology and the procedure for guidance toward technique optimization. The rapid preparation of ultra-thin cross-sections can assist the advancement of protective coatings on the surfaces of cathode particles for an efficient characterization of bulk-to-surface interfaces.

Description: 

The full text of this paper will be available in September 2022 due to the embargo policies of ACS Applied Energy Materials. Contact summit@sfu.ca to enquire if the full text of the accepted manuscript can be made available to you.

Language: 
English
Document type: 
Article
Rights: 
Copyright resides with the author(s).
Sponsor(s): 
Natural Sciences and Engineering Research Council of Canada (NSERC)
MITACS
Statistics: